English
GermanDescription
The Ares Preamp is a reproduction of the EP-3 unit in bypass mode. It uses a charge pump to get 18 or 24v from a 9 or 12 volt source. There is also an output buffer on the end (adapted from the ClinchFX EP-Pre) that preserves the tone but gives it a much lower output impedance than the original.
This kit contains the PCB and all necessary parts. The enclosure can be selected, please select one knob for 6,3mm shaft separately.
Here is the bill of material: bill of material
This project is by Aion Electronics, in collaboration with Musikding. If you have any problems with the contents of the kit, please contact Das Musikding (Klaus). Since the modifications require some basic knowledge, this project is rather for more experienced builders.
Here is the direct link to the manual with layout and schematic:
Instructions
Here you can find build reports on this project: Build Reports
