Daydream kit

Item number: 2747

Multiband filtered delay.

Category: PedalPCB Modulation

Enclosure: 125B drilled+ 11,00 €125B+ 6,00 €none

starting from 62,00 €

Final price incl. VAT, plus shipping (mitttel)

Available.

Shipping time: 3-7 Working days

Description

The Daydream splits the guitar signal into three parallel paths, each with an independent resonant filter applied. This results in multiple layers of cascading harmonic sparkles.

This kit contains the PCB and all necessary parts. The enclosure can be selected, please select 5 knobs for 6,3mm shaft separately.
Here is the bill of material: bill of material

This project is by PedalPCBs, in cooperation with Musikding. If you have any problems with the contents of the kit, please contact Das Musikding (Klaus).

Here is the direct link to the manual with layout and schematic:
Instructions

Instrument:	Guitar
Effect-Type:	Mod/Echo

Ratings (2)

Average product review

5 Stars

4 Stars

3 Stars

2 Stars

1 Star

Share your experience with other customers:

The most useful review

1 from 1 Customers found the following product review helpful

Kits missing components

Love the pedal but the kits is a little bit disappointing.
One resistor was missing, and there was one extra ceramic capacitor in the bag, but missing one electrolytic capacitor.
All bumpers were missing.
The pre-drilled enclosure is slightly off from the template, which resulting into over crowded between the pots and audio jacks, which also made my decal not fitting.
Yufei G., 15.05.2020

Total entries: 1

1 from 1 Customers found the following product review helpful

Very good although not perfect

A fun kit to build.

Quality components, all labeled and carefully packed.
There was an abundance of wires in the kit, so you can decide on your own internal color scheme.
Note that the FV-1 chip is not mounted on the board, so this is not a beginner grade kit!

The reasons it was not perfect are the following:
One missing resistor, the led fitting was missing the nut and the hole in the enclosure for the the led was actually to small.
Finally there was a three position switch in the kit, where a two position switch was intended for this specific application of the Pythagoras board.
Luckily these were all easy to overcome and in a couple of hours the delay trails were swarming the room.
Stan M., 08.05.2023