VTL5C1

Item number: vtl5c1

Category: Optocoupler


7,50 €

Final price incl. VAT, plus shipping (klein)

From Price per unit
3 6,80 €
Available.

Shipping time: 3-7 Working days



Description

Xvive VTL5C1, photocoupler with 4 leads.

Data sheet: VTL5C1 data

The "5C1" is not printed on the device, instead there is a red coloured point applied.


Ratings (2)

Average product review

5 Stars
4 Stars
2 Stars
1 Star

Share your experience with other customers:

Total entries: 1
3 from 5 Xvive not really compatible

I measured the transfer ratio of the original 5C1 and this Xvive replacement.
At low diode currents, they are about equal (0.2 mA > 80 kOhm). At high diode currents (10 mA), the 5C1 reaches 200 Ohms, while the Xvive type doesnt go beyond 500 Ohms. Using these in a compressor might cause a low compression ratio. You may need to mod the driving amp gain.
Also, the spread in the transfer is high. I bought five, one had to be rejected because the transfer was off by more than 200% (lowest R was 1200 Ohm).
The other four had spread within 30%, and only two were within 10%, so I just could use these for my stereo opto compressor.
So I would recommend other (high gain, low-ohmic) variants of the Xvive opto ports to be a 5C1 replacement. For stereo, buy more than you need and do your own matching.
When you want to use these for just switching (Ampeg, Mesa Engineering), you will not have these problems. The leakage of the cells is pretty low.

., 10.12.2017
Total entries: 1


Other customers have also bought the following items
3PDT footswitch

3PDT footswitch

3,90 € *
VTL5C3

VTL5C3

6,50 € *
10k metal film 1%

10k metal film 1%

0,08 € *
6,3mm Mono jack

6,3mm Mono jack

0,95 € *